Frame-relay Lab3

[stevenmk28]

LAB3
Ive have configured Frame-relay between Routers 1 & 2 using
point-to-point subinterfaces and I'm having trouble getting layer three connectivity. My pings between both routers are unsuccessful. I've include the output for command show protocol below as well. Any help would be greatly appreciated =)
!
interface Serial1
no ip address
encapsulation frame-relay
no keepalive
!
interface Serial1.1 point-to-point
ip address 172.16.10.1 255.255.255.0
frame-relay interface-dlci 100
!
interface Serial1.2 point-to-point
ip address 172.16.11.1 255.255.255.0
frame-relay interface-dlci 101

Router 2-

ip address 172.16.20.1 255.255.255.0
frame-relay interface-dlci 200
!
interface Serial1
no ip address
encapsulation frame-relay
no keepalive
clockrate 4000000
frame-relay intf-type dce
!
interface Serial1.1 point-to-point
ip address 172.16.10.2 255.255.255.0
frame-relay interface-dlci 200
!
interface Serial1.2 point-to-point
ip address 172.16.11.2 255.255.255.0
frame-relay interface-dlci 201
--More--
R1#sh protocol
Global values:
Internet Protocol routing is enabled
Ethernet0 is administratively down, line protocol is down
Serial0 is administratively down, line protocol is down
Serial1 is up, line protocol is up
Serial1.1 is up, line protocol is up
Internet address is 172.16.10.1/24
Serial1.2 is up, line protocol is up
Internet address is 172.16.11.1/24


R1#sh protocol
Global values:
Internet Protocol routing is enabled
Ethernet0 is administratively down, line protocol is down
Serial0 is administratively down, line protocol is down
Serial1 is up, line protocol is up
Serial1.1 is up, line protocol is up
Internet address is 172.16.10.1/24
Serial1.2 is up, line protocol is up
Internet address is 172.16.11.1/24

[dpeters]

it would help if you have one of routers set up to route the dlci from point to point or just create a tunnel on the device... ?