frame relay and ospf

mk1819 · Joined: 29 Dec 2003 Posts: 2 Location: America/New_York

can somebody point me in the right direction ?
Under the lab senario, I got R1 pinging R3 via frame relay only and
R2 pinging R4 only. I used the dlci statements on all the routers
Then I added ospf but I still cannot route between the 4 routers.
I have 2 subnets. One betwen R1 and R3 and the other between R2 and R4. It's not an addressing issues. When I turn on OSPf , nothing happens in terms that I cannot ping from R1 to R4.

any clues
thanks all

Headhunter · Posted: Sat Feb 14, 2004 4:05 pm Post subject:

What do you see when you do debug ip ospf events or debug ip ospf adj

perumal Meenakshi1563 · Joined: 05 Nov 2003 Posts: 8 Location: Asia/Singapore

Mark,

correct me if I am wrong , u have 2 subnets

subnet 1: R1S0 ---FR---R3S0
subnet 2: R2S0 --- FR---R4S0

R u using any other subnet to connect the either R2 & R3 or R1 to R4 ?

U need connctivity either r2 & r3 or r1& r4 to connct the above mentioned subnets, then u run the ospf.

also ospf neigh statment is needed if you use the physcial interface in FR.

Regds

perumal Meenakshi1563 · Joined: 05 Nov 2003 Posts: 8 Location: Asia/Singapore

Hi Kaz,

Nice to see you again..

Hope you have enjoyed your long holiday
Smile

Regards
PMS

mk1819 · Joined: 29 Dec 2003 Posts: 2 Location: America/New_York

thanks all that reply. i will try it next time. It's just that due to my busy schedule, I missed 2 of my lab times !!!