Configuration Example: Lab #3 - frame-relay point-to-point

Headhunter · Posted: Mon Dec 20, 2004 4:19 pm Post subject:

I assume this is R7 we are talking about...
Are the clockrates set, is the frame-relay intf-type dce on the serials...

Neil5163 · Joined: 11 Dec 2004 Posts: 7 Location: Europe/London

thanks tom

Koen - R6 on pod4

Yea the clock rates are set on that router by default what i'll do next session is lower the clock rate when i torubleshoot because the line keeps going up and down

Headhunter · Posted: Tue Dec 21, 2004 3:17 pm Post subject:

try setting the frame-relay lmi type
frame-relay lmi-type ansi
and do this on the switch and your routers

could be a cabling issue...

Neil5163 · Joined: 11 Dec 2004 Posts: 7 Location: Europe/London

to be honest i did think that

however im not techinical enough to know for sure and thought it more likley i havent been doing something right

i set the same config up a few days previous and got all the routers except R2 on pod 4 working via frame relay so this is why i've had a bit of headache trying to troubleshoot this.

Oh well i guess its good for the learning process but if there is hardware fault theres not a lot i can do really except report it. But i havent seen anyone else flag this so maybe it is me.

Neil5163 · Joined: 11 Dec 2004 Posts: 7 Location: Europe/London

ok

i have set the lmi type to ansi on routers and R6 (switch) line protocol went up and then came down.

I think i'll try and get this checked out. i'm pretty sure im doing this right i've got frame relay to work before.